Take a very close look at the picture. These are all the gaskets and seals you will need to replace if you open up your 722.4 transmission that was produced from 1984 to 1990 for all 6 and 8-cylinder passenger cars that had a displacement of 2.6 liters or more (EXCEPT the 300D and 300TGD. Make sure to check your serial number before ordering. The latter 722.4 transmissions have some different seals in them.
Product Details
NEW IN 2026! This reseal kit does include the two orings in the bottom of the K1 and K2 drums that are riveted in place. Many kits do not replace these, but we think it is a mistake. Every one of these drums that Kent has opened up recently has O-rings that are hard or broken. Kent has sourced high-heat Nitrile O-rings. We include just the O-rings. Kent's kit includes the basic tools and hardware needed to drill out the rivets and install countersunk sheet-metal screws, which can be purchased separately below.
Please see related products below to purchase this hidden seal installation kit.
Related Products:
1981 to 1995 722.3 722.4 Modulation Pressure Test Kit
Too much pressure and you will blow the seals. Too little pressure and you will wear out the clutch packs. Now in stock. When installing a new vacuum modulator on your transmission, you most likely will need to adjust it. There are two ways to do this.
